What to Do When Your Atomizer is not working with Your MOD/APV or Battery?

The most common problem that you face when you vape is that sometimes e-liquid Australia seems that the atomizer and clearomizers have stopped working along with the mod. Many vapers start believing that there has been a problem in the attachment, while others throw out the entire device out of frustration. In case you too have reached the same point then here are some damage control tips that you should follow when the atomizer stops working with the device.

Maintain Properly:

You can follow all the damage control tips, but if you do not maintain the atomizer, clearomizer or the device properly then all these steps that you have undertaken will not matter at all. Therefore, the first thing that you should do is maintain the device. In order to maintain it properly you will have to wipe the gear with the help of a damp cloth. Make sure that you are cleaning the portions that have small crevices. These areas are small and thus they absorb all of the junk and debris, particularly because e-liquids are prone to attracting the rest of the gear.

See if it’s a Connection Issue:

Maximum number of times it is the connection issue. You need to find out whether there is a connection problem or not. In order to solve you have start off by touching the base portion with clearomizer, atomizer or your device. The parts where a connection has been made make sure that you inspect them thoroughly and see to it that the areas have not been covered by the debris. Also ensure that are they making a proper connection. Many a times the screw inside the atomizer is not screwed in entirely, the center in the device is put much lower than it should have been put or the pin on the clearomizer or the atomizer needs to put down minutely.

Adjusting the Center Pin:

If you are able to adjust the pin then you can solve the problem of connection issue. The small connects tip that is put inside the 510 connector is known as the center pin. When the atomizer is screwed into the device the center of the device and the atomizer’s pin meets and the connection transmits the power. Many a times when an atomizer stops working it is really the problem of the center pin. Either the pin is too low or the atomizer is too high. This is the reason manufacturers have replaced it with an adjustable center pin. In case your device does not have an adjustable center pin then you can pull the pin a bit up with the help of something small. However, you might damage the o-ring seal that is there in between the center and the connector, so you have to be very careful with this.

Check if it’s the Coil’s Fault:

Many a times when you are using the clearomizer it can be the fault of the coil. Though manufactures try to make the perfect coil yet it may so happen that the coil that you receive is already damaged. Nonetheless, it can also be a simple connection problem. For these moments it is highly recommended that you buy some extra coils along with the clearomizer and the atomizer.